26 May 2004 To: Art Freiley From: Dick Simpson Subject: Noise Calibrations at DSS 14 Table below summarizes RSR results from noise measurements made at DSS 14. For 20 May, X-RCP, S-RCP, and now S-LCP data have been analyzed; I will fill out the table one more time when the X-LCP analysis is complete. The methods described in my two previous memos were applied here. Tndu is the noise diode temperature from comparing ambient load levels with levels when the noise diode was added to the ambient load. Tndl is the noise diode temperature from comparing sky noise levels (zenith) with and without the noise diode; a nearby Top was taken to be the reference. Channel Quantity Date N Minimum Maximum Average ------- -------- ---------- -- ------- ------- ------- S-LCP Tndu 2004-04-08 4 11.30 12.20 11.60 S-RCP Top 2004-04-08 3 19.75 20.27 S-RCP Tndu 2004-04-08 2 14.67 15.74 S-RCP Tndl 2004-04-08 2 16.25 16.34 X-LCP Top 2004-04-08 2 18.48 18.49 X-LCP Tndu 2004-04-08 2 16.25 16.34 X-LCP Tndl 2004-04-08 2 17.16 17.76 X-RCP Top 2004-04-08 3 19.60 19.85 X-RCP Tndu 2004-04-08 2 20.48 22.96 X-RCP Tndl 2004-04-08 2 21.58 22.20 S-LCP Top 2004-05-13 5 23.49 24.16 23.71 S-LCP Tndu 2004-05-13 3 12.07 12.93 12.58 S-LCP Tndl 2004-05-13 3 12.08 12.36 12.20 S-RCP Top 2004-05-13 7 19.08 19.28 19.13 S-RCP Tndu 2004-05-13 4 15.60 16.16 15.81 S-RCP Tndl 2004-05-13 4 16.06 16.10 16.09 X-LCP Top 2004-05-13 10 17.16 17.37 17.28 X-LCP Tndu 2004-05-13 3 15.35 17.31 16.28 X-LCP Tndl 2004-05-13 3 17.40 17.60 17.50 X-RCP Top 2004-05-13 1 18.34 X-RCP Tndu 2004-05-13 1 23.76 X-RCP Tndl 2004-05-13 1 23.58 S-LCP Top 2004-05-20 3 23.57 23.89 23.75 S-LCP Tndu 2004-05-20 4 11.36 12.07 11.75 S-LCP Tndl 2004-05-20 2 11.82 12.04 11.93 S-RCP Top 2004-05-20 3 18.73 19.08 18.85 S-RCP Tndu 2004-05-20 5 14.83 16.49 15.99 S-RCP Tndl 2004-05-20 3 15.82 15.86 15.83 X-RCP Top 2004-05-20 5 18.38 18.67 X-RCP Tndu 2004-05-20 2 22.60 23.05 X-RCP Tndl 2004-05-20 2 23.25 23.37 Although there are some variations, the results from 13 and 20 May continue to look consistent; the biggest difference is in the noise diode temperature on S-LCP (added today). I'll attach the S-LCP spreadsheet to this message and will FAX the plots of log(power) versus time.